2010 Freightliner Patagonia 4×4 Expedition Vehicle was built as our 2010 Show Truck, this Expedition Vehicle has tons of upgrades. Self-Sufficient Vehicle-Dependent Living.

Contact Information

Contact Rene’ VanPelt
: 417-582-5050
: United States, Missouri, Nixa
Visit Website

Price: $315,000.00


Global Expedition Vehicles: 2010 Freightliner Patagonia 4×4 Expedition Vehicle with 19,000 Miles.

Features include: 60mm body construction, 3-175w Solar Panels, 710Ah AGM Batteries, Fischer Panda AGT 6000 Diesel Generator, Outback Power System with 2600W Inverter/Charger, Marine-grade Wiring, Diesel Heating System, Diesel Hydronic Heater on timer system for cold-weather Freightliner engine starts, Air Conditioner, Exhaust Fan, 125g Fresh Water, Thetford Cassette Toilet, Extended Cab Freightliner M2 with High-End Upfit including Leather Air-Ride Seats, Woodgrain Dash & Trim, GPS & Backup Camera; 300g Diesel Fuel Capacity, Front and Rear Winches, 70g Gasoline Tank for Toys. Aluminum Roof Rack with Storage box. HID lights installed on Roof Rack, Michelin 445/65R22.5 XZL tires . . . And Much More.

Patagonia Body

Body dimensions – Length 17’6″ (5334 mm), Width 8’ (2438mm), Height 7’3″ (2209mm)
Body Construction- SCS (Structural Composite Sandwich) 3 ply body panels. A highly insulating structural core sandwiched between interior fiberglass reinforced polyester (see details on website engineering page)

SCS Panel connections are made by 1344 # per square inch adhesive bond
SCS Wall thickness 2.36″ (60 mm)
SCS Floor panel, 4.33″ (110 mm), with integrated welded steel frame and surfaces of fiberglass reinforced polyester
G-KAS mounting (GXV-Kinetic Attachment System) body mounting system is a three point connection between the body and the chassis, with 2 structural isolation bearing points and one or more pivot points. This system allows the truck frame to flex to its maximum position and isolate that dynamic force from the expedition body. (see details on engineering page)
Cab-to-Cabin pass Thru

Entrance and Storage Doors: Lowered Entry Doorway coupled with electric step provides ease of access. Entry is lit by motion-sensing LED safety light. Entry and Storage doors are integrated into wall panels for added security.
Over-sized storage compartment accessible by 4’x4′ doors located on the left & right at the rear. Full 8′ width storage area will hold one ATV or two small motorcycles.

Windows / Skylights

Premium Armor Vision™ windows of dual-paned glass with integrated shades and insect screens. Built especially for Expedition Vehicles. Excellent thermal properties and noise filtering. Dual steel locking points. Flush-mount with outside wall, and paintable to match expedition body.
1 Dometic Skylight, with Integrated Blinds and Mosquito Screen

Body Options

Paint Expedition Body to match chassis
Locking Cab to Cabin Access Door
GXV exclusive Natura™ Opening Wall (see details on engineering page)
Additional windows or skylights
Ramps and winch for toy loading.
Awning: 12v or manual


Inner Dimensions of the Cabin

Length: 17’1″ (5232 mm) *
Width: 7’7″ (2311 mm)
Height: 6’7″ (2006 mm) *

Kitchen / Galley / Dining

U-shaped seating area for up to 4 people with adjustable swivel top table on pedestal is located on the left side at the front of the cabin

Seating area converts into additional sleeping area

Wood dining table.

Booth seats are covered in faux leather or upholstery.
Storage cabinet with shelves above refrigerator
Storage cabinet above with 3 drawers below located adjacent to dining
2 reading lamps illuminate the dining table area.
Magazine rack

Slide-out Pantry located in lower cabinet line: 15″ x 36″
All drawers and cabinet doors are equipped with positive locking hardware
Stainless steel sink has prep area / drain board incorporated into it, single handle faucet
Marine grade Vitrifrigo® stainless steel 2-drawer, 2.7 cu. Ft. freezer / 3.7 cu. Ft. refrigerator with a positive lock system.
Webasto® Diesel Cook top. Flameless diesel burner is integrated into a CERAN® cooking surface designed for 2 small, or 1 large, pot or saucepan. Control panel includes a temperature control, high-elevation button, hot surface indicator.
Microwave/convection oven with bake, roast & grill features. 1.2 cf, stainless steel
Stainless steel towel bar

Bed Area

Queen-size mattress in the rear of the living area. Size: 60″ x 80″ ( 152 4 mm x 2032 mm )
Windows with Screens and Roller Shades located at both the head and foot of the bed
Reading light on flexible arm
Above bed storage compartments
36’’ deep Wardrobe for hanging clothes with pull-out closet rod

Wash Room

Thetford® Cassette Toilet
Oval Stainless Steel Sink with faucet
Shower – Adjustable height head
Teak medicine cabinet with mirror
Teak sink cabinet for storage with solid surfacecounter-top

Interior Finishes

Ceilings: Washable Fiberglass Surface
Flooring: Plynal® or Engineered Hardwood
Walls: Washable Fiberglass Surface
Cabinetry of Alder, Maple or Oak, on lightweight plywood
Countertops: Solid Surface

Interior Options

Hand crafted wood kitchen cabinets made of Bamboo or Exotic Woods
Countertops: Granite or Recycled Materials
Backsplash or Wall Splash of Stainless Steel or Tile
Adjustable electric bed lift system
Booth Upholstery: Custom Fabric or Premium Leather
Ceilings: Padded vinyl panels
Wall Covering: Commercial grade vinyl
Flooring: Tile or Stone
Washer and Dryer Combo
Built in Coffee Maker

0 554

Bryan Freeman

I started Extreme 4x4 Nation with the goal to unite the off-road community with a common cause and interest. It's been a long and hard road but we've come a long way. Join the Nation and support our community today!